The Febco 825YA does have a different outward appearance from the 825Y. The end connections of the 825YA have integral flanged union connections to allow the valve to be installed in different configurations. We call this an angle pattern valve, thus the “A” suffix on the model number. Other than the end connections, all the parts are the same as the 825Y.

FEBCO825Y spec Sheet

Another model you may run into is the 825YAR. This model is a variation of the 825YA. It has the same angle pattern end connections, but also has replaceable check seats. All other parts are identical to the 825YA.

First, let’s take a look at the Febco 825Y model. This model uses a “WYE” pattern body to house the check valves, thus the “Y” suffix on the model number. The check valves are plastic poppet style and use a Buna rubber for the check disc and relief valve disc. The check valve seats are cast into the body of the valve and cannot be removed. The RV seat is replaceable. This is the base model for this series. Other than some slight variations, the rest of the models are basically the same.

Febco825Y Repair Kit

Most variations of the Febco 825Y series can not be distinguished by outward appearance alone. In order to view the differences you will have to go inside the valve. The 825YR was created with  replaceable bronze check seats. The “R” suffix stands for “replaceable” referring to the check seats. As for the 825YS, it uses silicone rubber in place of the Buna rubber used for the check and relief valve discs. All other parts on both models are identical to the 825Y. The 825YS is still in production, but the 825YR is no longer produced since the 825Y now comes standard with replaceable seats.

Febco825Y test ports

In my area I mainly test and repair the Febco 825Y series reduced pressure principle assembly in sizes 2″and smaller. My question concerns the model numbers. I have seen the 825Y, 825YR, 825YS, and 825YA. Can you explain the difference between these model numbers, and what they indicate?

1 1/4" Bronze Anti-Siphon Pressure Vacuum Breaker Backflow Preventer, Quarter Turn Shutoff, Lever HandlesThis 1 1/4 IN Watts series 800M4QT anti-siphon pressure vacuum breaker backflow preventer helps prevent the reverse flow of polluted water from entering into the potable water supply due to backsiphonage. It consists of bronze body construction, silicone rubber check valve disc, plastic check valve seat, stainless steel springs, a bonnet with silicone rubber O-ring seal, a lightweight plastic disc float, lever handle shutoffs, and test cocks for winterization draining. It is ideal in health hazard continuous pressure applications such as irrigation systems and industrial process water systems where the water enters the equipment at or below its flood rim. Maximum pressure is 150 psi (10.3 bar). Minimum pressure is 15 psi (55kPa).

After you remove the old stem o-ring, you can proceed with cleaning up the stem. You will want to clean up any scale build on the stainless steel stem. Once the stem is clean you can replace the o-ring and apply some lubricant. This will protect the o-ring from damage when the stem is screwed back into the disc holder. Now you can reassemble the check in reverse order and replace the rubber disc.

Browse by Catagory Boilers Burners Blowers/Motors Expansion Tanks Fittings Furnaces HVAC Oil Pex/Radiant Plumbing Pool Heaters Pumps Storage Tanks Thermostats/Controls/ Tools Water Boosters Water Heaters Water Filters Valves Venting