PVC Flexible Duct – 405mm (Diameter) * 7.62M (Length) The 405 mm in diameter PVC duct has a length of 7.62M and is made out of a PVC material. It is able to endure temperatures between -20°C and +80°C. It is built with a steel wire helix frame....

All of our stainless steel valves are approved for potable water. If the valve is going to be in contact with any potable water, a stainless steel valve must be used.

While our valves are ideal for a range of plumbing and vehicle heating and cooling applications, unfortunately we cannot recommend using one for low pressure propane because it would be too dangerous in the event of leakage.

Customer Reviews, including Product Star Ratings help customers to learn more about the product and decide whether it is the right product for them.

We use these in our craft brewery on glycol chiller lines. Some are mounted horizontal and some are mounted at a 30 degree angle. Originally had them mounted vertical but didn’t like our system configuration that way however, we saw no problems with any of the mount orientations.

it would be nice to be able to wire into valve so we don't need junction box, but that would make it not so water resistant

Valve has a good feeling feel about it, gear box is strong and slow open/close helps with water hammer. does not need 5 lbs to close like diaphragm valves i have been using

Motorised Electric Ball Valve - 3-Way AC - 3/4", 3.5N.m, Stainless Steel, 110V - 3-Point The motorised electric ball valve consists of a 3-Way 3/4” stainless steel valve, has a 3.5N.m operating torque and the actuator requires AC110V power. It...

The valves do not come as a V port from the factory but if requested can be made to order. We can offer a V port valve in 15, 75, or 90 degrees. If you wish to place an order for a V port valve please contact our sales staff for a quote.

Yes, we do, but they are not shown on our web site. Please provide the specification to our customer service department in order to get a quote.

Sorry, we do not have a motorized ball valve with a 1 or .5 second run time. We do have a large variety of other run times, starting at 12 seconds and going upwards of 60 seconds.

We have many Viton o-rings for sale in the Plumbing section of our website. We have 304 Stainless Steel valves but not 316L Stainless Steel valves.

Motorised Electric Ball Valve - 2-Way DC - 1/2", 2.5N.m, 24 V - On/Off The motorised electric ball valve consists of a 2-Way 1/2” brass valve, has 2.5N.m operating torque and the actuator requires DC24V power. It also consists of an on/off type...

To calculate the overall star rating and percentage breakdown by star, we don’t use a simple average. Instead, our system considers things like how recent a review is and if the reviewer bought the item on Amazon. It also analyzed reviews to verify trustworthiness.

Motorised Electric Ball Valve - 3-Way AC - 3/4", 3.5N.m, Stainless Steel, 110V - ON/OFF The motorised electric ball valve consists of a 3-Way 3/4” stainless steel valve, has a 3.5N.m operating torque and the actuator requires AC110V power. It...

Review your question to make any final changes. It may be sent to fellow customers so ask as if you were asking a friend.

Our motorized ball valves are used for this application all the time. The simplest approach is to use any motorized ball valve with an on/off wiring and set the default valve position to closed before installation. When the power is shut off, the motorized ball valve will automatically default to the closed position. Also, please be aware that the actuator has an IP54 rating, so be careful about getting the actuator wet, as it is not fully waterproof.

Sorry, our factory cannot replace just the motor for this motorized ball valve. You will need to replace the entire apparatus.

DEELAT has motorized ball valves in stainless steel, however, they are not recommended to use in a Class 1 Div 2 area. Even though, they can handle oil, the valve itself could possibly leak. Our manufacturer would need more much more details of the environment the motorized ball valve will be in to make sure its suitable.

Brassdielectric union

DEELAT carries SS304 stainless steel valves with double o-rings on both the ball and the stem. We do not have SS316L stainless steel valves or o-rings in Viton or Kalrez.

The operating temperature of the actual actuator, which is the motor that turns the ball valve, is -5°C to 60°C. The stainless steel ball valve can withstand -40°C temperatures.

Motorised Electric Ball Valve - 2-Way AC - 1", 3.5N.m, Stainless Steel, 110 V - On/Off The motorised electric ball valve consists of a 2-Way 1” stainless steel valve, has 3.5N.m operating torque and the actuator requires AC110V power. It also...

Dielectricinsulated unions

Hi David, thanks for your question. The valve is available in either BSPP or NPT thread specifications. If you need assistance with your purchase, please call our sales team at 1-888-667-5776 or email at sales@deelat.com!

This stainless steel ball valve cannot be used with natural gas. These stainless steel ball valves are made to have some sort of liquid run through them such as water or coolant. We can certainly work with you to source a valve that can handle natural gas.

We do not have control panels. The valve will be wired to the electrical system in the building where you are installing the valve. If you have any other questions or concerns please do not hesitate to contact us.

WattsDielectric Union

We do offer the valve body for this motorized ball valve in a 316SS version however it will not be able to withstand 1000 PSI. Max PSI it can withstand is 145 PSI. We do not offer any type of valve body that can hold 1000 PSI.

The motorized ball valve will not handle a steam operation. This is an electric ball valve that can be used in a wide range of electric setups.

This motorized ball valve cannot be used for potable water. However, a stainless steel motorized ball valve would work with potable water, although Deelat does not sell those.

Our brass motorized ball valves cannot be used for drinking or potable water. However, all of our stainless steel motorized ball valves are certified and are okay for use with drinking and/or potable water.

Magnetic Lifter – 1000 Kg Capacity The magnetic tool holder has a 1000 kg capacity along with a pull-off force of 3000 kg. The size of the unit is 305 x 145 x 135 mm. Function The magnetic heavy load lifter attaches to a lifting tool via the...

DEELAT brass motorized ball valves are lead free, but cannot be used for potable water. However, all of our stainless steel valves can be used for potable water applications.

We do not have a motorized ball valve that will be compatible with natural gas. The seals are not meant to handle gases and will leak.

Motorised Electric Ball Valve - 3-Way AC - 1", 4N.m, 230V - 3-Point The motorised electric ball valve consists of a 3-Way 1” brass valve, has a 4N.m operating torque and the actuator requires AC230V power. It also consists of a 3-point actuator,...

Swagelokdielectric union

The valve has an IP54 waterproof rating, which means it is protected from water spray and offers limited protection from water ingress.

We can offer these motorized valves with either a T or L port valve. Our recommendation is to please contact our customer support team to place the order for the specific valve you need. This way we can guarantee you are getting exactly what you need to complete your project

Motorised Electric Ball Valve - 2-Way AC - 3/4", 4N.m, 230V - ON/OFF The motorised electric ball valve consists of a 2-Way 3/4” brass valve, has a 4N.m operating torque and the actuator requires AC230V power. It also consists of an on/off type...

Motorised Electric Ball Valve - 2-Way AC - 3/4", 3.5N.m, Stainless Steel, 110V - ON/OFF The motorised electric ball valve consists of a 2-Way 3/4” stainless steel valve, has a 3.5N.m operating torque and the actuator requires AC110V power. It...

We do not recommend using the valve outdoors. This motorized ball valve has a gap between the actuator and the base. Therefore, rain will seep in and cause problems.

We received the units with pigtails and we hard wired them to a Johnson temperature controller. We put the Johnson controllers inside a NEMA enclosure.

Dielectric unionFor gas piping

The wiring diagram for D1156043 is actually available in the downloadable PDF spec sheet on this page above. Please download the spec sheet to find the diagram.

The valve arrives in the open position. If the power stops during usage, the valve remains in the same position. If the power to the control wire is cut, then the valve will close.

Motorised Electric Ball Valve - 2-Way DC - 3/4", 20 N.m, 24 V - 2S On/Off The motorised electric ball valve consists of a 2-Way 3/4” brass valve, has 20 N.m operating torque and the actuator requires 24VAC/DC. power. It also consists of a on/off...

Many of DEELAT's motorized ball valves have manual override switches; however, this is not one of them. If you have a specific application that requires a motorized ball valve with these specs and a manual override switch, call our sales team.

The motorized ball valve default position is set to open or close before installation. If the ball valve default position is set to close, then when the power is lost to the motorized ball valve, it will close.

Dielectric UnionStainless steel

The viton seals can certainly be applied on any of our motorized ball valves. D1165060 and other viton o rings can be found by searching for our o ring category in the search bar.

Johnson Controls A421 series has 10 sub models. The motorized ball valves with the most advanced wiring configuration are our proportional wiring motrized ball valves. Can you please provide your exact model #? You can either call us or email us at your earliest convenience.

The ball valve will maintain its position until you change the wire connection, usually via a switch. The warranty is 180 days. The maximum ambient temperature is 140 degrees F (60 degrees C) and the maximum medium temperature is 248 degrees F (120 degrees C). The waterproof rating for the unit is IP 55.

The motorized ball valve cannot solve this problem, but installing a water heater closer to the sink would save water. Deelat's electric water heaters are energy efficient and would be a convenient choice.

DEELAT motorized ball valves have been used for a few different brewing applications. The most common are for chilling fermenters with a glycol mixture. Our motorized ball valves can be used to transfer hot wort from the mash tun to the boil kettle which usually are temps below 194°F but are not recommended to be used the wort that is boiling. The max temperature these valves can withstand are 194°F. If you run boiling wort through the valve it will quickly diminish the gasket and seals in the valve causing leaks.

You can call us at 1-888-785-2677 to initiate a product or exchange, and you can also do it through your account interface on the website.

Dielectric Unionfor electrical conduit

Motorised Electric Ball Valve - 2-Way AC - 1/2", 3.5N.m, Stainless Steel, 110 V - On/Off The motorised electric ball valve consists of a 2-Way 1/2” stainless steel valve, has 3.5N.m operating torque and the actuator requires AC110V power. It...

Unfortunately our motorized ball valves cannot be used for natural gas. The seals are not made to withhold gas within the valve so there will be gas leaks which is very dangerous.

The DEELAT On/Off Motorized Ball Valves are one of the easiest valves to wire. The actuator will come with 3 wires; Blue, Brown, and Black. Blue is negative, Brown is positive, and Black controls the opening and closing of the valve. The blue and brown wire must be receiving power at all times. When the black wire receives positive power it will open the valve and when power is removed it closes the valve. These valves are usually controlled by a switch or controller meaning the black wire must be connected to the switch or controller because its the wire sending a signal to the actuator to open and close.

The seals that are inside the valve body of our Motorized ball valves are made out of EPDM (Ethylene Propylene Diene Monomers) which is a high density synthetic rubber that is extremely versatile with an ability to withstand 0 - 95 degrees Celsius. Please contact our customer support team at 1-877-956-5685 regarding samples by phone.

This motorized ball valve cannot be used with diesel fuel. The actuator does shut off after actuating and will remain open until switched/powered to close.

Do I need adielectric unionfor copper to stainless steel

We feature offers with an Add to Cart button when an offer meets our high standards for: Quality Price,Reliable delivery option, andSeller who offers good customer service “No featured offers available” means no offers currently meet all of these expectations. Select See All Buying Options to shop available offers.

DEELAT three-way valves do not have shut off, but the two-way valves do. Also, the valves come wired so that they can be connected to whatever power source you are using for your application.

In the event of power failure, the valve will go to the default position. The default position is set by the installer before installation and can be changed any time to open or close.

There was an issue with the valve delivery where I was charged some extra fees in error. One quick email to Chris at Deelat and everything was solved right away. Sometimes the unexpected happens, but they were very quick to correct it. A+ for customer service.

The valve does not draw any power from a battery, this actuator must be hard wired to a 12V DC power source. The actuator has an open close rate of 2 seconds, not 16. The reason for the rate of 2 seconds is because it's not a steady running time due to the DC motor inside. When opening the valve using the opening control wire, there is a current of about 55mA, and when the valve is entirely opened, there remains a 10mA current flow. When closing the valve, the current is at about 55MA as well, but when entirely closed, there remains a current at the range 0 to 10mA.

Motorised Electric Ball Valve - 2-Way - 3/4", 3.5N.m, 230 V - 3-Point The motorised electric ball valve consists of a 2-Way ¾” brass valve, has 3.5N.m operating torque and the actuator requires AC230V power. It also consists of a 3-point...

You can use DEELAT valves with steam, however, we do not recommend to use them with steam. The temperature of steam reaches right above the recommended temperature range of the valve which is 35°F-194°F (2°C-90°C). The admissible pressure is 2.0MPa (290 psi) and the closing pressure is 1400KPa 203 PSI.

Hi Ranger. We have white, red, yellow, blue and green. There will be MOQ for the order of the road studs, so please call our sales team at 1-888-667-5776 or email at sales@deelat.com for assistance.

You are correct, the motorized ball valve with 3-point wiring will need to be powered to open and close. If power is cut the valve will in fact stay in its current position just like you said.