Backflowprevention Sydney Water

Depending on the property you own or occupy, having a backflow prevention device may be required by your local water authority legislation. If you do have a backflow prevention device installed, this must be tested regularly (usually annually) and maintained, to make sure no wear or damage causes the device to fail.

backflowprevention valve - bunnings

Call now for one of our backflow specialists to assist you. Simply go to our Contact page to find your local Backflow Prevention specialist to assist you with your requirements.

Our team of backflow plumbers have been specially trained to install, maintain and test backflow prevention devices and we work Australia-wide.

Backflowprevention requirements NSW

ValvCheq RP03 (RPZ) backflow valves play a critical role in maintaining the safety and integrity of your water supply. They prevent backflow, a potentially hazardous condition where water flows in the opposite direction, which could lead to contamination of the water supply.

It’s your responsibility to ensure you are compliant and protecting the well-being of the community by having your property risk assessed and taking the steps needed.

High – where the potential failure or absence of backflow prevention may cause death Medium – where the potential failure or absence of backflow prevention may endanger health Low – where the potential failure or absence of backflow prevention may cause a nuisance but does not endanger health or cause injury

Backflow protectionplumbing

Unlike the Double Check Valve an RPZ will dump the contaminated water out of the port on the bottom of the device ensuring a higher level of safety. With a ValvCheQ RP03 reduced pressure zone valve in place, you can trust that your water supply is secure, maintaining the quality and safety standards that are essential for health and wellbeing.

A backflow prevention device or air gap is used to protect a potable water supply (drinking water) from pollution or contamination due to a back pressure in the pipe supplying the water. Any property connected to a mains water supply system should be assessed and classified for its risk level. This can be determined by the activities happening at your property. The levels of risk are:

Backflow prevention is a crucial part of protecting the drinking water for the people of Australia. It stops the potential contamination of our water supply, by ensuring the flow of water is not reversed due to a change in pressure.