Mixing valvewater heater

Zurn Water Pressure Reducing Valve NR3XL With Integral Strainer, Durable Composite Bell Housing Resists Corrosion, and Cartridge Design Is Easy to Repair.

MasterMixing Valve

Eliminate the wait for hot water in any plumbing system by using on-demand recirculation pumps. Works with any tank, tankless, or heat pump water heater, in any ...

Those boiler feed valves can have their downstream pressure set between 10 and 25 PSI. The expansion tank can handle pressures much higher than ...

Mixing Valvefor sink

20231117 — The Reduced Pressure Zone Valve Assembly, often shortened to RP or RPZ, is thought of as the appropriate solution for high hazard conditions.

3/4mixing valve

A backflow preventer is a device plumbers install on your home's water pipe to prevent contamination. The water should only flow one way, and that is in your ...

To calculate flow velocity, you have to know flow rate and pipe interior diameter. If you know mass flow rate, then fluid density has to be known. If the ...

WaterMixing Valve

1″ Pressure Vacuum Breaker Assembly. Designed for installation on potable water lines to protect against both back-siphonage and backpressure of contaminated ...

Watts Pressure Reducing Valves are used in commercial and residential applications to reduce incoming water pressure for protection of plumbing system ...

Mixing valvefor boiler

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

A RDC is similar to a DC in that it is a mechanical backflow preventer consisting of two independently acting, spring-loaded check valves. However, it usually ...

Product Using this Repair Kit, N/A 1310. Weight, N/A 10 g. Model 1310 Back Pressure Regulator Operation & Maintenance Manual (PDF, 27KB) ...

The Thermostat 518 accurately controls the room temperature for a hydronic heating zone using Pulse Width Modulation (PWM) technology. Simple up and down buttons and a display with large type make this thermostat easy to read and use. The 518 automatically detects a single auxiliary sensor to measure either outdoor, floor or remote room temperature. This easy to install thermostat is a direct replacement for tekmar Thermostats 507 and 508. An optional Adaptor Plate 012 is available which allows the thermostat to be installed onto a single gang electrical box.

Innovative push-to-connect design makes for quick and easy installation. Mixes hot water with cold to deliver tempered water at a controlled and safe temperature of 120°F (49°C). Protects from scalding and when installed at the water heater, provides more available hot water and helps prevent Legionella. Ideal for working in tight spaces. Faster install time and ease of use reduces installation errors.