lfusg-b-m3

Watts 0204152

The barrel design helps with installation in tight spaces. They also feature Viton O Rings to give a high level of performance and life.

They are available in 15mm and 20mm in 2 common configurations, FF BSP and Internal Flare. The body is made from DZR Brass to comply with Australian standards and conditions.

Watts USG-B-M1

Pressure Limiting Valves are ideal for installation with high pressure storage water heaters, water meter, appliances etc.

LFMMV

Love our Products? Send it a photo of you and your plumbing work, to be featured on our website. Send in a photo and we'll feature you on our homepage and socials.

Note:- This valve is of a piston based design and needs a vent hole to ensure operation. If this valve is exposed to high inlet pressures (e.g. Poor water conditions or under water hammer conditions),

To prevent malfunction of this valve, this hole should not be covered or filled in any way. It is recommended not to install this valve in enclosed spaces or areas where the venting of water has a

Installation is subject to the requirements of the applicable regulatory authority, the National Construction Code Volume Three – Plumbing Code of Australia, associated reference standards as