Water velocity in pipeChart

We offer air-conditioning thermostats with built-in air sensors to replace an out dated style thermostat for ducted air-condition units. Note: these are not suitable for floor heating.

Brent Baird with Instruments Direct demonstrates three techniques that will estimate flow velocity. The old school method utilizes a flow calculator slider ruler. With Brent’s particular ruler, by sliding to the known value for the inside pipe diameter (ID) in inches, the velocity in feet per second (FPS) can be read above the known value for volumetric flow in millions of gallons per day (MGD). Alternatively, the inside pipe diameter can be estimated by lining up the known values for velocity and volumetric flow and then looking at the value indicated under pipe diameter. Brent demonstrates that a cross reference chart performs the same calculations using a different visual.

Knowledge of flow velocity, volumetric flow rate, and pipe diameter can assist operators in selecting, installing, and troubleshooting flow meters. This week’s featured video will guide operators in the math used to calculate flow velocity using volumetric flow and or pipe diameter.

Water velocity in a pipeformula

Every floor heating installation requires a thermostat. Our range of thermostats allow you to manage your room temperature automatically.

With the video's final explanation of basic flow meter requirements, these calculations can be used to spot and avoid problem areas for flow metering in your distribution system.

For an elegant and contemporary style, touch screen thermostats will suit any modern home. Wi-Fi functions allow you to remotely control the temperature from your smart phone.

Both of these tools are based off the equation GPM=2.45*ID2*FPS. If neither of his reference tools are available, plugging in the known FPS value for velocity and the inside pipe diameter in inches will calculate the volumetric flow rate. By rearranging the equation to solve for FPS, the flow velocity can be calculated using FPS=GPM/(2.45*ID2). Remember to follow PEMDAS. To calculate the internal pipe diameter with known values for FPS and GPM, rearrange the equation to solve for pipe diameter: ID= √(GPM/FPS/2.45). If the value for the internal pipe diameter is unknown, Brent demonstrates how an ANSI chart can be used to find that value.