Although PRV issues usually happen slowly, sometimes problems can crop up overnight. If you have no water pressure throughout the house on both the hot and cold, your PRV may be bad. Make sure you check both the hot and cold water. If there is good pressure on the cold and not the hot it may be an issue with the water heater or the fixture itself.

Check out all of our Ace Hardware Home Services locations at:Home Maintenance Services & Repair | Ace Hardware Home Services

The PRV won’t last forever, though. They are made with rubber parts and springs that will eventually wear out or get gummed up with particles in the water. Usually, PRVs fail slowly over time. It may take a while for you to notice there is an issue, especially if your usage habits aren’t very demanding.

Hopefully, this information helps you out. If you have any questions, feel free to give Legacy Plumbing a call. We are happy to help in any way we can.

Few things are as essential as plumbing fixtures when maintaining and enhancing your home’s comfort. These fixtures help keep the water flowing where it’s needed

Repetitive knocking or consistent humming noises that seem to come from the walls when you run different fixtures are often caused by a failed PRV.

Legacy Plumbing’s service area is on the north side of the Dallas Metroplex. Most of the PRVs around here are located on the main water line right where it comes up under the perimeter of the home in the front flower bed.

There is one application of backflow preventers that is often overlooked — the use of backflow preventers with beverage dispensers. This application is important cross-connection control. New revisions of the standards that cover the devices used in this application were recently published. These newly published standards are ASSE 1022, Backflow Preventer for Beverage Dispensing Equipment (for carbonated and non-carbonated); ASSE 1032, Dual Check Valve Type Backflow Preventers for Carbonated Beverage Dispensers, Post Mix Type, and Non-Carbonated Beverage Dispensers; and ASSE 1024, Dual Check Backflow Preventers. ASSE 1024 is generally used in conjunction with water meters; however, there have been recent code changes that make it prudent to include in this list.

ASSE 1022 and ASSE 1032 previously only covered devices used with carbonated beverage dispensers. A significant revision is that these standards now also cover non-carbonated beverage dispensers, such as coffee makers and ice machines. This change provides protection for products where the choice of backflow prevention was unclear.

Frisco, Texas, is one of the best places to live in the US, thanks to its thriving economy, glorious landscapes, and reputation as one of

You might expect ghosts and ghouls from horror stories, right?  But a different kind of nightmare scares many adults — and it’s not haunted houses.

In the 2024 Uniform Plumbing Code®, dual check backflow preventers (ASSE 1024 devices) were added as an approved backflow preventer for non-carbonated beverage dispensers. The reasoning for this addition is that not all beverage dispensers (e.g. coffee makers) are installed with access to a drain. This makes the air gap and ASSE 1032 device impractical, as they could contribute to water damage.

The Pressure Reducing Valve (PRV) protects your home from water pressure that is higher than what the plumbing fixtures in your home were designed to handle. By code, water pressure inside your house should be between 40-80 pounds per square inch (psi). If the water pressure delivered by your water supplier is higher than that, a pressure reducing valve is installed on the main water line serving the home to bring this down to an appropriate level.

These noises can also be caused by other things as well, such as a failed expansion tank, quick closing solenoid valves on new appliances, bad vacuum breakers, faulty valves with loose washers, worn-out toilets fill valves, improperly strapped pipes, etc.

Sometimes the valve itself will burst and start leaking. If you have a muddy or flooded spot in the flower bed, this could be the reason.

2024 Uniform Plumbing Code®603.5.12 Beverage Dispensers. Potable water supply to carbonated beverage dispensers shall be protected by an air gap or a vented backflow preventer that complies with ASSE 1022. For carbonated beverage dispensers, piping material installed downstream of the backflow preventer shall not be affected by carbon dioxide gas. Non-carbonated beverage dispensers, such as ice makers and coffee machines, shall be protected by an air gap or dual check backflow preventer that comply with ASSE 1032 or ASSE 1024.

If your water pressure doesn’t seem to be as strong as it once was or you notice a significant loss of pressure when you use more than one fixture at the same time, your pressure reducing valve may be bad. If you don’t usually use different tubs and showers at the same time, you may first notice this issue when you have guests over and the demand is higher than normal.

Sometimes it can be a combination of these contributing factors. For more confirmation that the sound is caused by the PRV, go to where it is located and listen. It should be noticeably louder right next to the PRV.

When PRVs start to wear out, they can cause many strange issues with the water pressure throughout your home. As we go through these different symptoms, it is important to know that they will usually occur all over the house at the same time when they are caused by a failed PRV. If you are having any of these issues on only a single fixture in your home, then the issue probably isn’t with the PRV.

If your faucets, toilets, or appliances need frequent repair, this could be a symptom of high water pressure. Most fixtures are rated for a maximum working pressure of 80 psi. If you have a pressure that is continually higher than this, parts will wear out and things will break more quickly.

In this article, your local plumbing experts explain the symptoms of a bad pressure reducing valve that may need to be replaced.

It is sometimes possible to adjust the pressure at the PRV to lower it. However, if the PRV is more than a few years old, this is often risky. By attempting to adjust it, it may stop working altogether or even start leaking.

The beverage dispenser backflow preventer standards are another example of how standards evolve to keep current with changes in codes and new applications as appropriate when industry needs demand.

On homes built after 2010, it is more common to find them in other places. Check in the garage for a wall panel with plumbing pipes inside. We have also located them in the walls under stairs, closets, and laundry rooms.