Lower water usage means less strain on local water supplies, and reduced energy consumption means fewer greenhouse gas emissions from power plants. By installing a hot water recirculation system, you’re not only making a smart choice for your home but also contributing to a healthier planet.

Recirculatingpumpforwater heaterinstallation

Secret Sauce One of the best features of the Tekmar 356 Mixing Control unit is that it regulates mixing pumps in hydronic systems.This ability to fine tune the temperature at which a hydronic system runs allows a property owner to fine tune the comfort of their space. The Tekmar mixing control unit achieves its superior control over mixing pumps through an outdoor temperature reset sensor. In layman's terms, outdoor reset systems monitor weather conditions both in and outside of the home.So when outdoor temperatures are more frigid, the tekmar 356 can direct the mixing pump to raise the temperature of the hydronic fluid piped to a home's radiators. This provides more heat to the home.By the same token, when outdoor temperatures are warmer, the 356 can direct the mixing pump to run cool in order to maximize energy efficiency. This variable operation of the mixing pump in regards to outdoor temperature can boost a boiler's overall efficiency to levels unheralded without such control.

Water heater pump

The thermostat communicates with the 257, and if temperatures in a room drop below the set point too quickly or for too prolonged a time, the 257 can shift into high gear. This two stage operation allows the system to provide more even heat with a quicker heat-up time.The Tekmar 257 two stage control also lessens the cold pockets often found within rooms. And just as each coin has two sides, if the system should require less heat—say in the warmer fall months—the Tekmar 257 can keep operation in the low stage to conserve energy.

Best hotwaterrecirculatingpump

Boiler Rotation The Tekmar 257 also boasts equal runtime rotation technology. As the 257 is often used to control groups of boilers, this runtime rotation measures the amount of time each boiler in the system has run.If one boiler operates more than the other, the Tekmar 257 will power down the overused boiler and instead draw heat from the under-used boiler. This way both boilers in the system are likely to last longer and provide more efficient heat.Ease of Use The Tekmar 257 features a no-nonsense interface with an easy-to-read LCD screen and large buttons. The 257 is ideal for controlling hotel or apartment building boiler systems. The 257 can also tailor performance to combi systems which provide both heat and domestic hot water to ensure an ample supply of both.

The positive environmental impacts of hot water recirculation systems are substantial. By reducing water waste and energy consumption, these systems help conserve valuable resources.

To further reduce costs associated with energy-saving retrofits, homeowners can take advantage of various rebate programs. The Home Energy Rebate Programs, introduced as part of the Inflation Reduction Act, offer significant financial incentives for energy efficiency and electrification projects.

Whether you’re washing dishes, taking a shower, or doing laundry, you get hot water instantly. This can significantly improve your daily routines, making your home life more comfortable and efficient.

Water heater pumpfor house

Recirculatingpumpforwater heaterdiagram

For those who live in the "rust belt", Tekmar offers the 664 snow detector/melting control unit equipped with temperature and moisture sensors that can operate snow melt equipment beneath two outdoor slab surfaces.When temperature drops below freezing with moisture in the air, the 664 then kicks on attached snow melt technologies. This Tekmar melting control goes beyond simple on/off operation, though. The 664 truly is a snow melting control, able to direct two boilers into separate snow melting zones, each with differing temperatures.Take, for example, the owner of an office building. In winter, snow melt is needed in both the blacktop parking lot as well as the building's front steps. Installing a Tekmar 664 would allow the owner of this building to set different heat settings beneath these surfaces: a lower temperature beneath the heat-friendly blacktop and a higher temperature for the cold, concrete front steps.The 664 can also place priority of one zone above the other. So if the business owner wants the parking lot cleared before the steps, the 664 can direct heat to ensure that is exactly what happens. The 664 can also control a variable speed mixing pump to make sure the hydronic fluid running throughout the snow melt system runs neither too hot nor too cold.

Overall, while the pump does use some electricity, the savings in water and improved efficiency can offset this, making hot water recirculation systems a smart and eco-friendly choice for your home.

Getting the most out your hydronic heating system can be difficult. Luckily, Tekmar has a device that can increase efficiency and streamline the system's operations effortlessly.How's this possible you ask? The Tekmar 257 for instance, is a boiler control system - a maestro if you will, that ensures optimal performance by operating multiple boilers in symphony, conducting the flow of water to ensure a harmonious distribution of heat. Here, we will examine the benefits of each Tekmar 257, 356, and 664 hydronic heating controllers. Tekmar 257 The Tekmar 257 features two stage control. This means the 257 can operate the attached boiler in either a "low" or "high" gear. The thermostat communicates with the 257, and if temperatures in a room drop below the set point too quickly or for too prolonged a time, the 257 can shift into high gear. This two stage operation allows the system to provide more even heat with a quicker heat-up time.The Tekmar 257 two stage control also lessens the cold pockets often found within rooms. And just as each coin has two sides, if the system should require less heat—say in the warmer fall months—the Tekmar 257 can keep operation in the low stage to conserve energy. Boiler Rotation The Tekmar 257 also boasts equal runtime rotation technology. As the 257 is often used to control groups of boilers, this runtime rotation measures the amount of time each boiler in the system has run.If one boiler operates more than the other, the Tekmar 257 will power down the overused boiler and instead draw heat from the under-used boiler. This way both boilers in the system are likely to last longer and provide more efficient heat.Ease of Use The Tekmar 257 features a no-nonsense interface with an easy-to-read LCD screen and large buttons. The 257 is ideal for controlling hotel or apartment building boiler systems. The 257 can also tailor performance to combi systems which provide both heat and domestic hot water to ensure an ample supply of both. Tekmar 356 Secret Sauce One of the best features of the Tekmar 356 Mixing Control unit is that it regulates mixing pumps in hydronic systems.This ability to fine tune the temperature at which a hydronic system runs allows a property owner to fine tune the comfort of their space. The Tekmar mixing control unit achieves its superior control over mixing pumps through an outdoor temperature reset sensor. In layman's terms, outdoor reset systems monitor weather conditions both in and outside of the home.So when outdoor temperatures are more frigid, the tekmar 356 can direct the mixing pump to raise the temperature of the hydronic fluid piped to a home's radiators. This provides more heat to the home.By the same token, when outdoor temperatures are warmer, the 356 can direct the mixing pump to run cool in order to maximize energy efficiency. This variable operation of the mixing pump in regards to outdoor temperature can boost a boiler's overall efficiency to levels unheralded without such control. Built for the Average User Like the 257, the Tekmar 356 is designed for simple use. A large screen and three simple to use buttons allow a homeowner or property owner to get maximum performance from their boiler without a PhD in hydronics. Once installed, the unit quickly sets up for simple use.Even the most basic controls on the 356 allow a homeowner to tailor a boiler to their personal tastes. For intricate cases, the Tekmar 356's advanced controls provide all the finesse necessary. If these controls weren't already enough, the 356 also features a smart diagnostic routine which checks to ensure proper operation of each component in the system.The ability to modulate boiler temperature with precision makes the 356 perfect for a wide range of heating applications including radiant systems and commercial baseboard heating. Tekmar 664 For those who live in the "rust belt", Tekmar offers the 664 snow detector/melting control unit equipped with temperature and moisture sensors that can operate snow melt equipment beneath two outdoor slab surfaces.When temperature drops below freezing with moisture in the air, the 664 then kicks on attached snow melt technologies. This Tekmar melting control goes beyond simple on/off operation, though. The 664 truly is a snow melting control, able to direct two boilers into separate snow melting zones, each with differing temperatures.Take, for example, the owner of an office building. In winter, snow melt is needed in both the blacktop parking lot as well as the building's front steps. Installing a Tekmar 664 would allow the owner of this building to set different heat settings beneath these surfaces: a lower temperature beneath the heat-friendly blacktop and a higher temperature for the cold, concrete front steps.The 664 can also place priority of one zone above the other. So if the business owner wants the parking lot cleared before the steps, the 664 can direct heat to ensure that is exactly what happens. The 664 can also control a variable speed mixing pump to make sure the hydronic fluid running throughout the snow melt system runs neither too hot nor too cold. NEXT: View All Tekmar Controls

A hot water recirculation system is a system designed to provide you with instant hot water throughout your home. It works by continuously circulating hot water through your pipes so that when you turn on a tap, hot water is immediately available, eliminating the wait time and reducing water wastage.

Pros and cons of hotwaterrecirculatingpump

Don’t wait another day for hot water to reach your faucet. Contact us now to get started! We can’t wait to help you elevate your home comfort with InAir’s superior HVAC services.

Understanding these components and types can help you decide which hot water recirculation system best fits your needs and lifestyle, providing you with the convenience of instant hot water while saving time, water, and energy.

A hot water recirculation system works by keeping hot water flowing through your pipes so that it’s always ready when you need it. Here’s a simple breakdown of how it operates:

The less hot water you waste, the less energy your water heater has to use to reheat water. Demand-controlled and timer-based systems, in particular, are designed to be energy-efficient, running the pump only when necessary to minimize energy consumption. This can lead to significant savings over time.

Getting the most out your hydronic heating system can be difficult. Luckily, Tekmar has a device that can increase efficiency and streamline the system's operations effortlessly.How's this possible you ask? The Tekmar 257 for instance, is a boiler control system - a maestro if you will, that ensures optimal performance by operating multiple boilers in symphony, conducting the flow of water to ensure a harmonious distribution of heat. Here, we will examine the benefits of each Tekmar 257, 356, and 664 hydronic heating controllers.

Like the 257, the Tekmar 356 is designed for simple use. A large screen and three simple to use buttons allow a homeowner or property owner to get maximum performance from their boiler without a PhD in hydronics. Once installed, the unit quickly sets up for simple use.Even the most basic controls on the 356 allow a homeowner to tailor a boiler to their personal tastes. For intricate cases, the Tekmar 356's advanced controls provide all the finesse necessary. If these controls weren't already enough, the 356 also features a smart diagnostic routine which checks to ensure proper operation of each component in the system.The ability to modulate boiler temperature with precision makes the 356 perfect for a wide range of heating applications including radiant systems and commercial baseboard heating.

Ready to experience the comfort of instant hot water in your home? Let InAir Heating and Air handle your installation needs! We are dedicated to enhancing your home comfort with comprehensive HVAC solutions tailored to your unique needs. Trust InAir for all your HVAC requirements: from maintenance to repair, and installation.

There are three main types of hot water recirculation systems: demand-controlled, timer-based, and continuous. Each type has its own advantages and is suitable for different needs and preferences.

Hot water recirculation systems are designed to solve this common problem by providing instant hot water throughout your home. These systems continuously circulate hot water in your pipes, ensuring that you don’t have to wait for the water to heat up each time you turn on the tap.

The Tekmar 257 features two stage control. This means the 257 can operate the attached boiler in either a "low" or "high" gear.

Hotwaterrecirculatingpumpinstallation diagram

One of the primary benefits of hot water recirculation systems is the convenience they offer. Imagine never having to wait for hot water again.

By constantly circulating hot water through your pipes, the system ensures that when you turn on a tap, you get hot water instantly without waiting for it to travel from the water heater to the faucet.

This blog post will educate you on how hot water recirculation systems work, their benefits, and why they might be the perfect solution for your home. By the end, you’ll understand how these systems can save you time, water, and money while enhancing your daily comfort.

Hot water recirculation systems offer a range of benefits that enhance your convenience, conserve water, save you money, and reduce your environmental footprint. They are an excellent investment for any homeowner looking to improve their home’s efficiency and sustainability.

Recirculatingpumpfor tanklesswater heater

Investing in a hot water recirculation system not only improves convenience and efficiency in your home but also aligns with sustainable practices, making it a smart and eco-friendly choice for homeowners looking to enhance their quality of life while reducing their environmental footprint.

Additionally, combining hot water recirculation systems with energy-efficient technologies like heat pumps can further enhance overall efficiency and reduce energy costs. Heat pumps are known for their ability to transfer heat efficiently, and when paired with a hot water recirculation system, they can provide an optimal solution for maintaining hot water availability with minimal energy use.

Hot water recirculation systems offer a seamless solution to the common frustration of waiting for hot water. Whether opting for demand-controlled, timer-based, or continuous systems, the benefits of instant hot water, reduced water wastage, lower energy bills, and eco-friendliness are compelling reasons to consider this technology for your home.

By saving water, you also save money on your water bills. Additionally, because hot water recirculation systems reduce the time it takes to get hot water, they can lower your energy bills as well.

Hot water recirculation systems are excellent for water conservation. In a typical household, a significant amount of water is wasted while waiting for hot water to arrive at the faucet.

By circulating hot water through your pipes continuously, these systems ensure that hot water is immediately available, drastically reducing the amount of water that goes down the drain while you wait. This can save thousands of gallons of water annually, making a big difference in your overall water usage.