For tankless water heaters, the pump must have a high enough flow rate to activate the water heater. I would recommend at least 10 gallons/minute. For pipe runs of over 100’, you would need a bigger pump, over 20 gallons/minute.

City ofWoodlandUtilities

Dispense water from your water filtration unit or reverse osmosis system with this Single-Handle Water Dispenser Faucet. This faucet requires a drain ...

HYDAC proportional pressure reducing valves are continuously adjustable valves. Therefore, they control the pressure of the consumer depending on the ...

In this article, your local plumbing experts explain the symptoms of a bad pressure reducing valve that may need to be replaced.

City ofWoodland waterbill

Stop waiting for water to heat up and watching money go down the drain. The New Recirculation Pump Kit from Rheem provides immediate hot water using the ...

City ofWoodlandlogin

HF Scientific Inc. 16260 Airport Park Drive. Suite 140. Fort Myers, FL 33913. USA. Website: https://www.hfscientific.com. Toll Free: (888) 203-7248. Fax: (239) ...

Demand hot water circulation systems are not new. They have been around a long time, but recently with our current, and predictably constant water shortage, they could be a great contributor to water conservation. The concept is, that at the push of a button, water is pumped from the hot water line back into the cold-water line at the water fixture furthest from the water heater, usually a bathroom. A temperature sensor detects an increase in the water temperature as hot water arrives and shuts the pump off while you are getting ready for your shower. No water is wasted. The pump runs for less than a minute. Hot water is immediately available wherever the pump is installed, usually at the bathroom sink. Whether hot water is then available at other locations in your house depends on the plumbing layout. Ideally if there is only one main hot water line with small branches to the kitchen, bathrooms, and laundry, installing the pump at the end of the line should provide hot water within seconds anywhere in the house. (Remote buttons can be placed at other locations.) If the farthest point is at the end of one branch, say to the master bath, and the kitchen is at the end of another branch, this will affect the time it takes for hot water to reach the kitchen. A second pump would be required.

Water Technology Expertise. Water Technology ConsultantsTM Inc. is an independent water technology consulting company based in Evergreen, Colorado, that ...

City ofWoodlandpay bill

Dormont Manufacturing's at amazing rates, Contact Lance Restaurant Supply today!

Woodland waterPark

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Sprinkler Backflow Preventers. Backflow: it's a dirty word when it comes to any type of plumbing or irrigation project. The prevention of back-flowing ...

These Demand systems are simple to install- you can get kits that provide the hardware you need. However, they do require an electrical outlet. In the case of a bathroom sink, on outlet can usually be added by extending wiring from an existing outlet by the sink. This is the only part of the installation that requires trade skills and incidentally, a permit. The “button” is actually a doorbell button and is low voltage. An optional remote receiver hooks right up to the unit so it can be turned on from anywhere in the house with a remote transmitter button. Read more at gothotwater.com

B1156F Watts 1/2" IPS Bronze High Capacity Feed Water Pressure Regulator with Purge Lever 100 PSI.

6815-3/4-700, 3/4″ NPT BRASS PRESSURE REGULATOR (700 MAX PSI) ... Image may slightly vary from actual product. ... TEEJET 6815-3/4-700, 3/4″ NPT BRASS PISTON-TYPE ...

Are you wasting good, treated, pumped from a well, while you wait for your shower to get hot? Do you have to run water in the kitchen to get hot water to the dishwasher? Are you committed to water conservation? Did you know that every home wastes thousands of gallons of water a year waiting for it to get hot?