Any order changes and/or cancellations prior to shipment must be requested (in writing) within 24 hours of the order being processed to avoid restocking fees. Order cancellations after 24 hours are subject to 50-90% restocking fees, depending on where the order is at in the production cycle.

LPP light poles, brackets, and arms are engineered according to AASHTO standards and accepted commercial criteria. Proper selection for an application is based on information such as EPA, wind zone, mounting height, and other attachments (such as banner arms and flags). This information is necessary to ensure proper engineering. LPP and its vendors assume no responsibility for proper loading analysis and/or product selections. Design information (such as EPA charts and wind maps) found on our websites and selection guidance offered by LPP customer support representatives are provided as general guidelines only. The customer remains solely responsible for proper selection of the light pole, luminaire, and/or related accessories that adhere to all applicable requirements, including (but not limited to) EPA design criteria, job specifications, and engineering requirements. To ensure proper selection of the light pole, luminaire, accessories, and/or foundation, LPP recommends the customer consult a qualified engineer to analyze the loading and design criteria for the specific application.

McLovins Pet offers Dog and Cat Bowls Pets Water and Food Bowl Set, Cat Bowls Food and Water with Automatic Waterer Bottle for Dog & cat.

22in. length Propane/LP gas hose and regulator assembly. Brass male pipe threaded end (3/16" ID and 3/8" OD) attaches to ...

AK HR low pressure brackish elements are selected when high rejection and low operating pressures are desired. These elements allow significant energy savings ...

We recommend vibration dampeners be used when (1) light poles are being installed on a parking ramp, deck, bridge, pier, airport, train or subway hub/terminal, or known problem area, (2) a load of 0.75 EPA or smaller is going on the light poles and (3) light poles are being used as camera supports and/or will have non-standard appendages attached to them. The LPP warranty excludes light pole failure caused by harmonic vibration.

Watts 0063235 2" LF007M1QT Backflow Preventer. The Reduced Pressure Backflow Preventer reverses flow of used or dirty water from entering back into the water ...

Minimum working pressure: 1.45psi (10 kPa). Maximum working pressure: 150psi (10 bar). Temperature Range: 33˚F – 240˚F (5˚C – 116˚C). Specifications. Air ...

All three types of radiant floor heat (air, electric, hot water) can be further subdivided by the type of installation.

Light pole vibration problems are caused by environmental factors that vary by geography. They do not result from improper materials and/or poor manufacturing processes. If you have concerns about light pole vibration for a specific project you are working on, please contact LPP customer support.

When it comes to Reduced-Pressure Zone Backflow Preventers, you can count on Grainger. Supplies and solutions for every industry, plus easy ordering, ...

It’s our goal that all LPP customers are completely satisfied with their products. We take extra care during the quotation and order processing stages and work with our customers to verify that the ordered bill-of-material fits the application requirements. Very few of our orders are ever cancelled or returned, and that’s because we want your project to run as smoothly as you do.

For products that have shipped, no product may be returned without a completed Return Materials Authorization ("RMA") form that can be requested in writing at quotes@willbrands.com. We will not accept any returned product without an RMA and no returned product will be accepted until it has been inspected and determined to meet the criteria stated below. At customer's written request and cost, products not accepted for return will be shipped back to customer. The return policy applies only to products purchased from LPP.

Flow Control Valves & Fittings. Valves and accessories for controlling flow in hydronic heating, plumbing, and solar systems.

Tekmar 519 24V Thermostat. View compatible models. SKU. TEK519. Brand. Tekmar. Available for order. Add to List. $153.64. Decrement Qty Increment Qty.

WATTS LFUSG-B-M2 0204143 3/8 THRD BRASS THERMOSTATIC MIXING VALVE LEAD FREE at Hajoca - Costa Mesa.

Estimated manufacturing lead times are the best estimate based on current business conditions and may change due to factors including factory capacity and availability of component parts such as base castings, fabricated parts, electronic components, and other factors.