These fittings ensure that water is only able to travel in one direction preventing backflow, often used in conjunction with Auto Shut-Off Valves.

3/4backflow preventer

Hydronic underfloor heating depends on radiant heat transfer. The system supplies heat to the floor or panels on your walls by circulating heated water through ...

N36 Other disorders of urethra N36.4 Urethral functional and muscular disorders Advertise with Us | License ICD10 Data

1 inch Backflow Preventerhome depot

iSpring has been dedicated to providing high quality drinking water to families across the U.S. since 2005. From various residential water filtration ...

Installed in mixing mode, the mixing valve’s thermal actuator will sense the temperature to automatically proportion the flow of hot and cold fluid from two inlet ports to produce the desired outlet port temperature.

A brass nipple does a pretty good job of electrically isolating the black tank of a water heater from copper tubing.

Watts 9D Series 9DM3 1/2 Backflow Preventer, Union Female Threaded x Union Joint, 175 psi Max Pressure, Brass available at Hep Sales & North Main Lumber.

11/4backflow preventer

1 inch Backflow Preventerfor sprinkler system

The TBV cartridge can be integrated into a 4-way manifold to monitor inlet flow and divert the fluid based on temperature. Cooler fluid goes through the valve bypass, while hotter fluid goes through the system’s cooler.

2inch Backflow Preventer

ThermOmegaTech’s thermostatic mixing valves/diverting valves use a thermal actuator to accurately proportion and maintain flow in response to temperature. These 3-way thermostatic valves are used in a variety of industrial, aerospace, & defense applications.

WattsBackflow Preventer

Shop for 6 in. Stainless Steel Flanged Backflow Preventer (0111605) at Pollardwater.

Regulator, 1/2" Appliance, 1/2 PSI Inlet, Converts to Nat. Gas (6" WC) or LP Gas (10" WC), Range: 2.8" - 5.2" W.C. Maxitrol, RV47CL-1/2.

1Check Valve

Thermostatic Mixing/Diverting Valve Product Brochure Thermostatic Mixing/Diverting Valve Installation and Maintenance Instructions

21 Oct 2012 — Heat traps are made to completely isolate the heat inside of a water heater so that it...

In mixing applications where a controlled temperature outlet is required, the 3-way control valve (M/D) will modulate between the hot and cold inlet feeds (ports “B” and “C”) to mix your fluid to the desired specified temperature exiting the “A” port.

1 May 2018 — When the sensor detects leaking water, the system will automatically shut off the feed and sound an audible alarm. This disables the cold water ...

In diverting applications where the fluid must be directed from one section of a system to another, the thermal diverting valve (aka thermal bypass valve) will modulate inlet fluid temperature and divert return flow through a cooler/ heat exchanger or bypass it to a reservoir/ bypass loop when fluid temperatures are satisfied. This action assures rapid system warm-up, accurate control of fluid temperature, and reduced back pressure in the return.

The thermostatic mixing valve/diverting valve is designed to maintain or proportion flow based on temperature in mixing or diverting applications.

Installed in diverting mode, the valve’s thermal actuator will sense the fluid temperature and automatically divert or switch the inlet flow to either of the two outlet ports depending on the valve’s specified temperature requirements.