If it’s been sitting in place for many years or you have hard water corrosion, it may take some convincing. Attach a pipe to the end of your wrench for added leverage.

Wattswashing Machine Valve

Even if the second shut-off valve is still functioning and not leaking, you may want to consider also replacing it at this time.

DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact webmaster@doityourself.com. Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2024 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.

Washing machine Valvesize

The following navigation utilizes arrow, enter, escape, and space bar key commands. Left and right arrows move across top level links and expand / close menus in sub levels. Up and Down arrows will open main level menus and toggle through sub tier links. Enter and space open menus and escape closes them as well. Tab will move on to the next part of the site rather than go through menu items.

Since your water is turned off at the primary source, you can turn your valves on (if they’re not already) and drain water from the lines.

SharkBitewashing machine valve

Washing Machine ValveBox

Unless you want to deal with a water fountain when you open the water shut-off valve, shut down the water supply to the laundry room before you start tinkering with your plumbing.

Some washing machine shut-off valves will have screws holding them in place. Look for them before spending too much time trying to heavy-hand the removal.

Twist or screw the new shut-off valve or valves into place, using the reverse of whatever technique it took to remove the old one.

Your hoses should be attached to the valves. Some valves are further down in the wall, behind the drywall, paneling, or other wall finish.

If this is the case, use a drywall saw for sheetrock or a keyhole saw for wood. Make your cut clean and save the piece you remove so you can make the wall repair later on.

The Zurn 8-F210R Fire Riser Check is used in a fire sprinkler system and provides zone backflow prevention and features pressure gauges with isolation valves upstream and downstream and includes a drain port and valve to easily drain the sprinkler system for maintenance.

DualWashing machine Valve

Slowly turn on the shut-off valve, watching for leaks. If you find leaks, remove the parts, apply more plumber’s tape and reassemble.

Even if your setup brings a bit more complexity, this is a task most DIY homeowners can manage without calling in the pros.

Washing machine valvereplacement

Your shut-off valve will be behind the washing machine. Most sit about hip height and include both cold water and hot water valves.

It’s also useful in managing maintenance and repairs, so when it springs a leak or freezes in place it’s time to address the issue.

If you try everything but still can’t get the valve to release from the pipe, you’ll need to cut out a section of pipe that includes the valve.

Some unfortunate designs hide the shut-off valve behind the wall. If you’re lucky there’s an access panel or a way to reach it through the existing hole the hose goes through.

Unplug your washing machine from the power source to avoid accidents. You’ll probably need to move the washing machine out of the way to give yourself adequate workspace.