Your call is answered by qualified people who will gladly discuss your project in detail, advise you professionally and never sell you inappropriate products.

Recirculation pumpGrundfos

NOTE: Each relief mechanism is set to the required pressure and sealed before leaving the MGM factory. When ordering the customer should state the model number and pressure desired.

Outdoor ON-DEMAND tankless recirc system. For up to 600 ft. of total pipe length and tankless flow requirement of .4 GPM or more. On-demand switch controlled.

Recirculation pumpwashing machine

The No. 210 & 213 series MGM Relief Valves are designed for the protection of piping and equipment from over-pressure conditions. They are available for any predetermined pressure from 50 to 1800 psig and will automatically reseat after discharge. Valves in this series feature American Standard 1/8” or 1/4” male and female pipe threads to mate with new or existing fittings or equipment.

Recirculation pumpinstallation

Outdoor tankless recirc system. For up to 100 ft. of total pipe length and tankless flow requirement of .4 GPM or less. Timer controlled.

Recirculation PUMPpiping Diagram

For outdoor tankless installation with a dedicated return line and with MORE than .4 GPM flow requirement. Up to 600 ft. of total pipe length.

Other features of the MGM No. 210 & 213 series relief valves are seat discs made of Viton which provide a “bubble tight “ seal. Pipe Away Adapters are available for the direct connection of vent piping when required. Outage tubes (dip tubes) have been incorporated into the inlet end of the No. 213 series valves.

MGM Model 210J Relief Valves are positive pressure relief mechanisms for any predetermined pressure from 50 to 1800 pounds per square inch.

We're engineers passionate about home ventilation and serious about customer service – so you can count on us for carefully-selected equipment and expert advice to ensure your project is a success from specification to installation.

Recirculation pumpfor water heater

For outdoor tankless installation with a dedicated return line and with LESS than .4 GPM flow requirement. Up to 250 ft. of total pipe length.

Outdoor ON-DEMAND tankless recirc system. For up to 100 ft. of total pipe length and tankless flow requirement of .4 GPM or less. On-demand switch controlled.

These pumps are typically used in the Southern part of the US market where tankless heaters are installed outside to save on expensive air intake and exhaust systems. Use with tankless heaters without a built-in pump. Single pipe and dedicated return line models. Options include on-demand and timer controls.