Please visit www.galvinengineering.com.au to view the full warranty, our Installation Compliance and Maintenance & Cleaning information as well as any other additional information.

Shut-offvalvesymbol

The mini dual check valves are primarily designed to provide protection from potential contamination to the potable water supply in low hazard applications for individual fixtures.

While all reasonable care has been taken in compiling the information in this document, the designs, dimensions and products shown are indicative only and should not be relied upon without our prior approval. Due to our policy of continuous development, we reserve the right to alter any details of specifications or products without notice. All information, drawings, technical specifications and product designs remain the property of Galvin Engineering Pty Ltd.

Galvin Engineering products are covered under our Manufacturer's Warranty. Galvin Engineering products must be installed in accordance with the installation instructions and in accordance with AS 3500 and NCC Volume Three, relevant Australian Standards and local authorities applicable to product being installed. Water and electrical supply conditions must also comply to the applicable national and/or state standards, failing to comply with these provisions may void the product warranty and affect performance of the product.

Shut-offvalveDanfoss

Our range of backflow prevention devices are manufactured in our WA factory and approved to AS/NZS 2845.1. Constructed from dezincification resistant (DR) brass the units consist of two independently acting internally loaded check valves. With a low hazard rating the units perform to a maximum temperature of 60 degrees celsius and a maximum pressure of 1200kPa. All units can be installed vertically or horizontally however they must not be subject to flooding or freezing.

Shut-offValveSMC

The mini dual check valves are primarily designed to provide protection from potential contamination to the potable water supply in low hazard applications for individual fixtures.

Shut off valvehydraulic

Shut off valvefunction

VP series is a residual pressure relief 3 port valve with modular connection to SMC's AC series F.R.L unit.  It allows for space saving compared to non modular type.

Our range of backflow prevention devices are manufactured in our WA factory and approved to AS/NZS 2845.1. Constructed from dezincification resistant (DR) brass the units consist of two independently acting internally loaded check valves. With a low hazard rating the units perform to a maximum temperature of 60 degrees celsius and a maximum pressure of 1200kPa. All units can be installed vertically or horizontally however they must not be subject to flooding or freezing.

We are ISO 14001 certified and take sustainability seriously. Our products are environmentally responsible designed to be healthier for users, save water and/or energy, and minimise carbon footprint. Our target is to reduce our carbon footprint by 25%, and the use of non-recyclable/non-compostable materials across the company (e.g. plastics) by 50%.

Shut off valves isolate supplied pressure in a pneumatic system and exhaust downstream pressure for maintenance purposes. They can be used alone or connected to an FRL assembly using modular spaces, ultimately saving air line downtime and cost when maintenance is necessary.

The VHS series pressure relief valve provides a convenient means of isolating supplied pressure in a pneumatic system and exhausting downstream pressure for maintenance purposes.  The units can be locked in the exhaust position and can be an integral part of an energy isolation system.  Air flow direction is easily identified by handle orientation and labelling.