009-qt-fs 1/2

Unplug your washing machine from the power source to avoid accidents. You’ll probably need to move the washing machine out of the way to give yourself adequate workspace.

Watts009 BackflowPreventer

Slowly turn on the shut-off valve, watching for leaks. If you find leaks, remove the parts, apply more plumber’s tape and reassemble.

Some unfortunate designs hide the shut-off valve behind the wall. If you’re lucky there’s an access panel or a way to reach it through the existing hole the hose goes through.

Watts009installation instructions

DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact webmaster@doityourself.com. Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2024 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.

Twist or screw the new shut-off valve or valves into place, using the reverse of whatever technique it took to remove the old one.

WattsBackflowPreventer009Repair Kit

It’s also useful in managing maintenance and repairs, so when it springs a leak or freezes in place it’s time to address the issue.

Your shut-off valve will be behind the washing machine. Most sit about hip height and include both cold water and hot water valves.

If you try everything but still can’t get the valve to release from the pipe, you’ll need to cut out a section of pipe that includes the valve.

Even if the second shut-off valve is still functioning and not leaking, you may want to consider also replacing it at this time.

Watts 009m2qt Parts breakdown

watts009qt 1/2 repair kit

Even if your setup brings a bit more complexity, this is a task most DIY homeowners can manage without calling in the pros.

1/2backflowpreventer home depot

Since your water is turned off at the primary source, you can turn your valves on (if they’re not already) and drain water from the lines.

If it’s been sitting in place for many years or you have hard water corrosion, it may take some convincing. Attach a pipe to the end of your wrench for added leverage.

Unless you want to deal with a water fountain when you open the water shut-off valve, shut down the water supply to the laundry room before you start tinkering with your plumbing.

If this is the case, use a drywall saw for sheetrock or a keyhole saw for wood. Make your cut clean and save the piece you remove so you can make the wall repair later on.

Some washing machine shut-off valves will have screws holding them in place. Look for them before spending too much time trying to heavy-hand the removal.

Your hoses should be attached to the valves. Some valves are further down in the wall, behind the drywall, paneling, or other wall finish.