This product can expose you to chemicals including carbon black, silica - crystalline, formaldehyde, and lead which are known to the State of California to cause cancer, and lead, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Engine Health – Higher miles tends to result in increased build up and lower compression which can and will impact engine output.  Properly maintained engines will have better performance than abused or neglected engines.

Whitewater

Weather/Conditions – Temperature, humidity, altitude, and air density all impact engine performance.  Heat, high humidity, and thin air will all work towards reducing engine output

The Weistec Can Am Maverick X3 Oil/Air Separator System comes equipped with billet PCV adapter fittings for easy bolt on performance, and accumulates oil in the lower body which can be drained and recycled during every oil change.

Supporting modifications – The highest power levels require supporting modifications.  Depending on the engine, this could mean forged internals, built transmission, upgraded fuel system, 110+ octane race fuel, etc.

With our expertise and advanced patented award-winning technology, the LM-HT Concentrator™, trust us to handle your leachate management needs, optimizing clean water preservation back into the water cycle while maximizing operational efficiency and separating and sequestering contaminants of concern including PFAS.

ProSlide technologyinc

Future-proof by locking in your treatment and disposal solutions for the long-term in an unpredictable and ever-changing market.

Fuel – Fuel quality is HIGHLY important with performance vehicles.  Low quality and/or low octane fuel will greatly impact engine output and potentially even engine health.  Top tier brand premium fuels should always be used to achieve the best results possible.

Drivetrain – All wheel drive has higher drivetrain losses than rear wheel drive.  This results in lower numbers when testing on a chassis dyno.  Wheel/tire size and weight will also impact chassis dyno results

Water TechnologiesInternational

Some vehicles may have more oil consumption or "blow-by" than others. If you are unsure whether your vehicle may or may not be one of these, check the oil separator every few trips to ensure the separator system is not filled.

An oil / air separator, also known as a catch can or crankcase ventilation system, is designed to separate the clean air coming in from the air that has mixed with the oil in the crankcase. Without an oil / air separator, air mixed with oil can find its way back into the intake system which goes right to the combustion chamber. This could lead to decreased performance, greater emissions, oil buildup on engine valves, and it could reduce the effectiveness of high octane gasoline. Reduced effectiveness of high octane gas could cause engine detonation or “knock”. Our team at Weistec Engineering designed this system to prevent all this with our Weistec Can Am Maverick X3 Oil / Air Separator System. *Product may not be emissions compliant. Check local laws prior to installation.

VeoliaWater Technologies

Heartland’s Leachate Management Service (LMS) is a comprehensive turnkey solution to address the industry-recognized and growing challenges of leachate treatment and disposal.

Model – Manufacturers use the same engine in multiple model vehicles and often times they are in a different state of tune, for example: 2008 C63 and a 2008 CLK Black Series.  Both have the same engine, but the C63 has 451hp while the CLK63 has 500hp.  Naturally the C63 will show more gains as it starts at a lower level.

Heartland’s Produced Water Management Service (PWMS) unlocks responsible resource utilization and environmental stewardship for produced water. Systems significantly reduce transportation costs and minimize risk from future regulatory tightening.

Some Weistec Engineering performance upgrades may solely be used on vehicles in sanctioned competition which may never be used upon a public road or highway, unless permitted by specific regulatory exemptions (such as a CARB E.O.). For state specific details please visit the following website. http://www.semasan.com/emissions

WaterTechnology

Waterpark designer

Advertised gains are estimates of HP and Torque “at the engine” calculated from gains as measured on a Dynojet Dynamometer in ideal conditions and typically show the largest possible change.  Actual gains are dependent on the following: Learn More about Crank HP Vs Wheel HP

Model Year – Similar to above, as time progresses, Manufacturers tend to slightly increase power output via software from one year to the next or offer “Performance Packages” with increased power.  The engines remain largely unaltered and as a result, final tuned output remains the same, while the gains are lower as the starting point is now higher.

Heartland Water Technology is a technology-enabled holistic solutions company that reduces, separates, and converts challenging wastes. Its proprietary award winning direct-contact wastewater evaporation solution, the Heartland Concentrator™, has a proven track record of successfully treating a wide range of industrial wastewaters and utilizing waste heat (including landfill gas and engine/turbine exhaust) to fuel its process. The HelioStorm™ ultra-high temperature ionic gasifier offers a distributed solution for complete breakdown of a variety of feedstocks, generating clean hydrogen and converting carbon for beneficial reuse.

Inflatablewaterpark

WaterTechnology engineering

This policy only applies to installers and/or users who are in the United States, customers who reside in other countries should act in accordance with their local laws and regulations.

It is the responsibility of the installer and/or user of the product to ensure that it is used in compliance with all applicable laws and regulations. If a product was purchased in error, do not install and/or use it. The purchaser must arrange to return the product(s) for a full refund.

All performance modifications and installations are at the customer’s own risk. Weistec Engineering holds no responsibility either implied or otherwise for mechanical, electrical or other failure when using any aftermarket performance products.

Heartland's Biosolids Conversion process sets new standards in biosolids management. Designed to address growing uncertainty faced by wastewater treatment facilities, Heartland provides a cost-effective long-term disposal solution optimizing resource recovery and delivering assured PFAS destruction.

Two proprietary advancements lie at the heart of Heartland’s new process: the HelioStorm™ ultra-high temperature ionic gasifier and the Heartland Dryer featuring our proprietary LTC Dry™ technology (Low Temperature Conductive drying).