The UMV500-LF Universal UnderSink Thermostatic Mixing Valve is intended for use in under counter and under sink applications to prevent accidental scalding.

27 Jan 2023 — The reason behind this is primarily due to the connector—or orifice—size of the two types of gas. A liquid propane connector is much smaller ...

Have you registered for our Strata Community Education Seminars? We are kicking off with our Gold Coast seminar this Saturday and registrations are filling fast! To secure your FREE ticket to the Gold Coast seminar, click here to register online: eventbrite.com.au/e/… pic.twitter.com/em6Z…

WATTS® Valve Repair Kit, For Use With: Model LF25AUB, LF25AUB-Z3 1-1/4 in Water Pressure Reducing Valve, Import.

Watts Regulator Expansion Tank PLT Potable Water 2.1 Gallon 150 Pounds per Square Inch 0067370.

Most Councils are now enforcing backflow compliance, and are carrying out audits to ensure property owners maintain the devices on site and have them tested on an annual basis. Councils are also insisting that backflow endorsed plumbers note any non-compliant installations and defects on the statutory form 9s during the annual testing of the devices.

Backflow prevention is by installation of compliant prevention devices to town water supply system to prevent contamination to our drinking supply (potable water). The most common devices that are used are Double Check Valves (DCV) and Reduced Pressure Zone devices (RPZ). There are also statutory requirement for testing of these devices to maintain compliance.

lf during testing, an RPZ or DCV or any other testable backflow device should fail, the valve must be repaired, serviced or replaced and re-tested as per current plumbing regulations. Most new blocks of units built today will have containment devices at the boundary for fire and domestic as another level of protecting our water supply.

What is Back Flow Prevention? Backflow prevention is by installation of compliant prevention devices to town water supply system to prevent contamination to our drinking supply (potable water). The most common devices that are used are Double Check Valves (DCV) and Reduced Pressure Zone devices (RPZ). There are also statutory requirement for testing of these devices to maintain compliance. RPZ devices are installed in a property where there is deemed to be a high hazard such as wash down bays, close to the ocean, lakes and areas where there are chemicals stored. DCV devices are installed where there is deemed to be a medium hazard such as under fire hose reels. Low hazard devices are the vacuum breakers on hose taps and do not require testing, whereas the RPZ & DCV devices require testing every 12 months as per Australian Standards 3500 & AS2845.3. lf during testing, an RPZ or DCV or any other testable backflow device should fail, the valve must be repaired, serviced or replaced and re-tested as per current plumbing regulations. Most new blocks of units built today will have containment devices at the boundary for fire and domestic as another level of protecting our water supply. Most Councils are now enforcing backflow compliance, and are carrying out audits to ensure property owners maintain the devices on site and have them tested on an annual basis. Councils are also insisting that backflow endorsed plumbers note any non-compliant installations and defects on the statutory form 9s during the annual testing of the devices. It is also the plumbers responsibility to point out any defects or non compliant issues to the property owner. lf the property owner has no desire to comply; the council will eventually take up the issue with the owner direct. This overview is only a brief outline of backflow prevention and if specific requirements for a properties backflow prevention compliance is required, please contact a backflow prevention specialist for professional advice. This article was contributed by Rex Barnes of Barnes Backflow Testing and Solutions.

I need to install something to catch the water that comes off our garage roof and have it run to the drain next to our garage.

In this week's Smart Strata Update find out everything you need to know about smoke drift disputes and the extension of COVID-19 emergency provisions for bodies corporate. #stratamanagement #strata #smartstrata #stratamadesimple #stratacommunity pic.twitter.com/7krX…

Sticking with Icon 65mm x 3m PVC Round Len Downpipe would be best, as that should mate up with that 60mm dropper. Use can use a couple of screws to hold the PVC pipe to the gal dropper. Icon 65mm PVC Round 112deg Bends will be used to send the pipe over to the wall and then straight down to the drain.

It really helped when you talked about backflow prevention and how it helps avoid water contamination. Recently, my wife and I moved into another house, and we started to notice how our water tastes weird. We’re not sure if our home’s water could be contaminated or something, so we’ll look for a professional’s help. Thanks for the information on water backflow and how to deal with it.

RPZ devices are installed in a property where there is deemed to be a high hazard such as wash down bays, close to the ocean, lakes and areas where there are chemicals stored.

As opposed to connecting it to the drain, you might like to stop it 10cm from it, allowing the water to fall into it. Or, insert the PVC pipe directly into the mouth of the terracotta pipe. Patching cement can then be used to fill around the pipe and create a seal. The larger female end of a terracotta pipe is not readily connected to stormwater, whether that's 65 or 100mm. I'm unaware of a fitting allowing you to connect directly to it. There's a good chance that this is a sewerage pipe to which you are not allowed to connect stormwater in many areas.

19 Sept 2024 — Water pressure that's too low will reduce the system's ability to filter and deliver water at the expected rate. Most RO systems require a ...

Welcome to the Bunnings Workshop community @tmoyn. It's sensational to have you join us, and many thanks for your question about connecting downpipe.

• ASSE 1016. PRESSURE-BALANCING VALVE. K-304. K-304-K. K-304-PX. K-304-UX. K-304-PS. K-304-US. K-304-KS. Colors/Finishes. • NA: None applicable. Specified Model.

A simple garden shed that was built entirely from scrap Centenary carport components. I used 108x65 box beams as posts (although one is 158x65). Walls ...

Did you know that the Smart Strata website features an extensive list of strata industry events hosted by industry stakeholders? Find out more about upcoming events near you and register your attendance today! Find out more: smartstrata.com/even… pic.twitter.com/DiLW…

In this week's Smart Strata Update find out everything you need to know about management rights transfers, and have your say on body corporate manager licensing. Don't forget to register for our Strata Community Education Seminars this October: ow.ly/S1Q850GfDNh pic.twitter.com/Kjsx…

Series 909 may be installed in a vertical or horizontal line and in an accessible location to facilitate testing and servicing. A discharge line should be ...

Low hazard devices are the vacuum breakers on hose taps and do not require testing, whereas the RPZ & DCV devices require testing every 12 months as per Australian Standards 3500 & AS2845.3.

This 1/2 inch 009 reduced pressure zone backflow preventer assembly is designed to prevent the backflow of polluted water from entering into the potable water ...

Mechanically activates to replenish water in floor drain traps to prevent the escape of sewer gases. · Debris screen with large openings to prevent clogging from ...

Overflow Valve for SP30 Suction Pump.

It is also the plumbers responsibility to point out any defects or non compliant issues to the property owner. lf the property owner has no desire to comply; the council will eventually take up the issue with the owner direct. This overview is only a brief outline of backflow prevention and if specific requirements for a properties backflow prevention compliance is required, please contact a backflow prevention specialist for professional advice.

Strata Update: New Seller Disclosure Regime Update | Community Education Seminars – Townsville & Cairns Next Week! ARPC Chief Executive Introduced!

I'm wondering if I need to attach something like this and then run some PVC pipe (round or rectangular) down to the drain.  If so, how do I go from 65mm at the top of the pipe down to 100mm at the bottom?  Should I use square or round PVC?

At Smart Strata our purpose is to provide you with the latest strata news and events, a comprehensive industry supplier portal and the best educational tools on the market to be the most informative resource in the Body Corporate industry.

Are you looking to promote your services to the strata industry? List your business within our Industry Suppliers portal and gain valuable exposure to strata managers, committees, owners and residents who work, live and invest in strata properties. smartstrata.com/list… pic.twitter.com/TSso…