Adjusting water pressureswitch

You will need a water pressure regulator if your water pressure reaches levels near 80psi. In fact, building code requires water pressure regulators if psi reaches 80.

Loosen the lock nut, then, then you can either tighten or loosen the top screw to adjust the water pressure. Tightening the screw (to the right) will decrease the overall water pressure. Loosening the screw (to the left) will increase the overall water pressure.

How to adjustwater pressure regulatoron a well

If you are new to plumbing, it is best to contact a licensed plumber to assist you with this project and make sure it is completed properly.

This valve is frequently installed right after the main water shut-off and is needed on homes with high or variable water pressure. Without one, high water pressure can wreak havoc by bursting pipes, damaging plumbing fixtures, or even damaging appliances over time.

However, this does not mean that they could be found elsewhere. Unprofessional plumbers or homeowners may install pressure regulators in other parts of the home.

Water pressure regulatoradjustment clockwise

How to adjustpressure regulator

As high water pressure enters, the spring and diaphragm make it more difficult for water to pass. Conversely, as lower water pressure enters the valve, water easily passes since the diaphragm and spring are under less pressure. Thus, the water pressure regulator can regulate water pressure and be adjusted through the external screw that controls spring tension.

To test your water pressure, you can use any pressure gauge that attaches to hose bibs or faucets. They can be found at your local hardware store or on amazon.

As mentioned, they are typically found right after the main water shut-off. This is so high pressured water can be limited before reaching the rest of the homes plumbing system and causing damage.

Water pressure regulatoradjustment screw

The best home & commercial building inspection company in Florida. Serving Orlando, Tampa Bay, South Florida, & the surrounding areas.

Water pressure regulators or water reducing valves help to regulate pressure that enters your home. Too much pressure can damage your appliances, pipes, and fixtures.

How to adjustwater pressure regulatorwithout gauge

Adjusting the water pressure is fairly simple. First, go to your water pressure regulator and located the top screw and lock nut.

Cities require high water pressure for fire hydrants and for water to work against gravity and reach the top levels in multi-story buildings.

If you notice water hammering, misting sprinklers, dripping faucets, or variable water pressure, it might be time to replace your water pressure regulator.

A water pressure regulator also named a pressure-reducing valve (PRV), is a type of plumbing valve that regulates pressure as water passes through the valve.