Gamegenic SquireXL

For use in a bio-hazardous environment, a filtration unit can be installed on the Pipet-Aid pump which will filter both vacuum and pressure lines. Incorporating dual filters, the Pipet-Aid Biohazard Filter Kit has a retention efficiency of 99.9999+% for 0.1 micron particles and droplets.

A DCVA is effective against backpressure backflow and backsiphonage but should be used to isolate only non-health hazards.

1. Battery needs to be charged overnight.2. Battery dead. Replace with (4-000-035).a. Cut the label on the bottom along the seam of the handle. Remove the nose piece followed by the 5 screws. Flip the unit over so that the screw holes are now facing down, then you can open up the top half of the Pipet-Aid. The battery is held down bydouble-sided tape.

Pipet-Aid XL: It should take up to two and a half hours to fully charge the battery. You can still use the Pipet-Aid while it’s plugged into the charger. The charger also seconds as a power supply.

SidekickXL

1. Filter has been wetted. Replace with 4-000-0512. TC gasket missing in nosepiece, requires one on each end of filter (4-000-057)

Portable Pipet-Aid XL – 4-000-105, 4-000-2051. Plug in power supply/charger and use unit while it charges. Use only power supply/charger 4-000-065. Battery dead. Replace with (4-000-036).

Am insulating my garage wall as it is attached to the entrance hall which is cold. The outside tap is in the garage and will be behind the insulation. Local plumbers merchants couldn’t help with a suitable part so managed to source a 50mm extender from here which was delivered promptly. Very good product and excellent service. Will use them again if needed and will recommend them.

909 Brass RPZ Hot Water · 909 Cast Iron RPZ Less Fittings (Device Only) · 1 · 2 · Hydroflow. Products · About · Resources ...

I need this part asap as none of local shops stocked it so I ordered it late on a Saturday and they arrived Sunday early afternoon and wea exactly what I wanted

Gamegenic 100+XL

Unit needs to be recharged. Plug in power supply/charger and use unit while it charges, use only power supply/charger 4-000-065. If LED does not light, replace battery (4-000-036).

Pressure reducing valves are installed in water systems to reduce and stabilise inlet pressures from mains water supplies or boosted water systems. PRV pressure reducing valve comes complete with a gauge and is designed for hot and cold water services in domestic or semi commercial applications. A pressure reducing valve can be installed on hot and cold supplies to prevent excessive pressure at water outlets such as taps and showers. To Suit Pipe Work: 15mm (1/2" BSP) /22mm(3/4"BSP)Copper Pipe; Maximum Pressure at Inlet: 16 bar; Outlet Adjustment Range: 1 to 6 bar; Factory Setting: 3 bar; Maximum Working Temperature: 70C; Pressure Gauge Connection: 1/4" BSP; Pressure Gauge Reading: 0 to 10 bar;

Gamegenic Sidekick Pro 100+XL

Adjustable Water Pressure Regulator with Gauge and Filter, Brass Lead-Free 3/4" NH Thread for Camper, RV Trailer · Easy-to-adjust knob can be loosened with a ...

We are an independent online retailer of household plumbing and heating supplies, and other home DIY items.With over 10 years in the trade, we’re now providing a fast and cost-effective service to households across the UK.From showers and other bathroom fixtures to garden irrigation systems and even the extractor fans, we’ve got you covered.We aim high when it comes to customer service and our 5-star reviews on Google and Trustpilot are testament to that.The same goes for our after-sales care too, with a store-wide 30 day returns policy for peace of mind.All orders over £50 come with free delivery and are dispatched the same day if ordered before 2pm.

With Sea Tech fittings, small lengths of tubing can be eliminated by using our stackable connector configurations. Simply snap together Tees and/or Elbows to ...

3. Listen for slight click when buttons are first pushed. If not heard, micro switch is broken, replace wire harness (4-000-046).

Get free shipping on qualified 3/4 in Recirculating Pumps products or Buy Online Pick Up in Store today in the Plumbing Department.

Gamegenic Squire 100+XL

A water hammer arrestor essentially creates air chambers. This space allows the pressure that's built up to release within the air chambers instead of the water ...

1. Replace rubber insert (4-000-002) if worn2. Poor seal around filter; use Drummond filters (4-000-051) and be sure both black, rubbergaskets are on either end of the filter.3. Handle connector tubing has a pin hole in it. Cut out if long enough or replace (4-000-013).

Gamegenic SidekickXL

1. Replace rubber insert (4-000-002) if worn2. Poor seal around filter; use Drummond filters (4-000-051) and be sure both black, rubbergaskets are on either end of the filter.3. Handle connector tubing has a pin hole in it. Cut out if long enough or replace (4-000-013).

Pressure Reducing Valve GT/XT - Tri-Foam Colourshine Chemical Control XT – Chemical Manifold Aquaspray – 3 Bay Water Manifold ½ Female NPT Operating ...

1. Rubber insert has cotton plugs blocking flow. Clean out cotton plugs or replace rubber insert (4-000-002).2. Buttons in valve body dirty. Clean or replace (4-000-021).

Brilliant website. Easy to find the items we wanted and they were delivered really fast! Can't fault it. Will be buying again.

2. Check valve in nosepiece needs to be cleaned out. Push wire or paper clip through black O-ring to open up check valve. When opened, rinse float and shell with water or alcohol. Allow to dry and reassemble. Shake and listen for float to rattle. Reassemble into nosepiece and check for aspiration.

LEER 100XL Fit chart

Our unique rubber insert allows the user to use any serological, volumetric and/or blow-out pipettes in either glass, plastic or something similar with sizes ranging from 1 to 100mL.

Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

Original Portable Pipet-Aid: Charging the unit for up to 5 hours should completely charge the battery. It is recommended to keep the charger plugged in whenever not in use; this will ensure optimum battery life. All rechargeable batteries have a limited life span. Generally each battery will last approximately 1000 cycles (charges) and then must be replaced.

5 Aug 2022 — Zurn marked Backflow Prevention Day on 16 August by highlighting the importance of backflow prevention devices and the critical role they play ...

I found the product that I had been looking for, at the right price and available. Once ordered it was sent and arrived promptly and was exactly what I needed - all good, no worries!

AFFORDABLE AND DEPENDABLE WATER FED PURIFICATION SYSTEMS. Professionals know the fastest way to spotless windows is with a pure water system. These single and ...

3. Battery damaged by use of non-Drummond charger. Replace battery (4-000-035). Charger will have Cat# 4-000-030 printed on it and should be black.

The Pipet-Aid® XL also features a new, quieter, more powerful pump and comes complete with a power supply/charger, four extra filters, a holster-type wall bracket, and a removable stand.

Pipet-Aid XP/XP2: It should take up to two and a half hours to fully charge the battery. You can still use the Pipet-Aid while it’s plugged into the charger; the charger also seconds as a power supply.

The Pipet-Aid XP features three speeds on the buttons; (S)low, (M)edium and (F)ast. On the XPGravity, the fast speed on the dispense button is replaced with a (G)ravity drain. This featureallows the user to dispense the liquid by gravity; allowing the liquid to simply fall out of thepipette when the button is pressed…the motor will not run in this mode.

This popular online store offers a wide range of high-quality products at reasonable prices, backed by efficient delivery and excellent customer service, ensuring a seamless shopping experience for its patrons.... This popular online store offers a wide range of high-quality products at reasonable prices, backed by efficient delivery and excellent customer service, ensuring a seamless shopping experience for its patrons.

Gamegenic Sidekick 100+XL

I really am glad I went for this as a product. The ball valves are nice and easy in their action and the lever can be swapped about for best orientation. Good looking and great to have a semi permanent connection and separate options too. I'd get another one if I ever needed

Drummond Scientific's Pipet-Aid® XL Pipette Controller adds comfort without giving up control when under a hood. Repetitive lifting and angling the arm can be exhausting. Arm motion is reduced, and extended pipet use is made easier with the ergonomically designed, longer handle and adjustable sliding hand rest. Enjoy the accuracy, performance, and convenience of our industry-leading Pipet-Aids in a state-of-the-art tool that alleviates arm fatigue.

check-stop: A device used in deep-sea dredging to prevent the breakage of the dredge-line in case the dredge fouls on the bottom.